|
Bases
Sept 9, 2009 0:10:39 GMT -9
Post by Sirrob01 on Sept 9, 2009 0:10:39 GMT -9
I've slowly been working on making GSD files for the base shapes. i've almost finished all the circle sizes just 40 and 50mm to go. I've been matching them up to the blanks only. Figure once the blanks and gsd files are done converting the others will be a snap.
I'll probably move onto the hexagons next.
Is anyone else working on these?
|
|
|
Bases
Sept 9, 2009 4:52:21 GMT -9
Post by squirmydad on Sept 9, 2009 4:52:21 GMT -9
Thanks for doing that.
Eventually I will be working on a whole new system for doing the bases with layered PDF's. each base size would be a PDF, and the different textures on a separate layer. you would just need to turn on the layer of the texture you want and print them out with all the cutter registration marks.
Your cutting files will still work for this revision, but will just have to be adjusted to work with the new registration marks.
Nothings going to happen quick. I am putting off all this non-miniature stuff off until after the new year. I still want to get out a lot more figure sets before that. JIM
|
|
|
Bases
Sept 9, 2009 4:53:43 GMT -9
Post by squirmydad on Sept 9, 2009 4:53:43 GMT -9
I should have added, that I'd be happy to add your conversion files to the blank BASES page, thanks for doing this... JIM
|
|