|
Post by Vermin King on Jun 22, 2012 10:02:52 GMT -9
Okay, they are big, but you should be able to rescale and still have them buildable. I'm doing mine printing 2 pages per page and they still look big. I just thought these looked like fun. You have the option to customize the cars with whatever name you like as the driver. www.brother-rally.co.nz/entries/newCurrently Vermin King is the driver of model 1, Slacker Mike on 2, and Isaiah on 3. Have fun
|
|
|
Post by katsumoto on Jun 26, 2012 20:54:20 GMT -9
It is really brilliant. Thank you
|
|
|
Post by Vermin King on Jun 27, 2012 6:25:27 GMT -9
Construction on these is not difficult, but slightly different than in most of the car/vehicle models that I've done. I originally did these printed out at two pages per page, which is, I think, about 73% on scale. Looked too big next to figures, so I re-did them at 4/page and they look spot on. There were a couple of 'either small parts or big fingers' issues at that size, but nothing insurmountable, and at that size they are very solid. I think I'm going to make a bottom plate for each one. What rally race doesn't involve at least one rollover? I'll do that one like I did for my kitbash on Mater from Cars, just snag an image of a bottom plate for a different model and play with scale until it is close, then trim to fit.
|
|