|
Post by Vermin King on Apr 7, 2018 10:47:01 GMT -9
I took photos of the build. Not sure why I didn't post them. There are a lot of parts that are fold-overs on this. Start with those Since this was an early version, there are a few changes. Figures now are set up for One-Monk basing, and the axle attachment is open to allow for a toothpick axle that runs through the wheel hubs. Using a round toothpick, cut it off on each end where it starts to taper. The cabin is next The over-roof tops it off. The end pieces are fold-overs that glue under the center piece. Line up the black lines, then glue on top.
|
|
|
Post by Vermin King on Apr 7, 2018 11:03:07 GMT -9
This is about the fifth version of the over-roof, but it works. Build the roof and attach to the carriage before gluing the ends down. Also on the left side of the template is a crosspiece that glues between the yoke trees to create an H to glue underneath instead of edge-gluing only the yoke trees.
|
|
|
Post by missileer on Apr 9, 2018 19:09:52 GMT -9
I have no idea how the name translates to English, but I will definitely have to build one.
|
|