|
Post by vizenz on Jul 2, 2020 22:05:49 GMT -9
Hello, here is my Army of "KENO" of Tomoko's Steel Warriors. Everything is printed in 110% to fit the usual 28mm scale. It is just the beginning and I would like to add a lot of units to it. What did I finish so far? 2 Sets of Infantry (Imperial Guard and Regular Infantry (south) ) + 2 "Aktash" offroad cars. Take care and best regards, Andreas
|
|
|
Post by whiteknight06604 on Jul 3, 2020 8:41:09 GMT -9
I have to say those are amazingly clean and crisp vehicle builds.
|
|
|
Post by Antohammer on Jul 3, 2020 22:58:29 GMT -9
I have to say those are amazingly clean and crisp vehicle builds. i quote him!!!! you seriously did a good job vizenz !!! when i try to make 3d paper stuff i endup putting it together with scotch tape and unholy words ahahahahah
|
|
|
Post by vizenz on Jul 4, 2020 1:04:48 GMT -9
Thank you for your kind words. Tomoko's vehicles are very great designed and everything fits fantastic. But to be honest, my builds have a few little flaws (for example on one vehicle is one wheel not flat on the ground).
Best regards, Andreas
|
|
|
Post by Vermin King on Jul 4, 2020 11:33:57 GMT -9
A couple helpful hints.
1) I have yet seen anyone use scotch tape and end up with a build they are satisfied with. Use low moisture PVA, or clear Crafters Precision Adhesive, or possibly cyano-acrylate (if you are fast and accurate)
2) When I put wheels on vehicles, I will glue one wheel in place and then shim the body so that it is at the proper height based on that wheel. Then when you glue the remaining wheels on, they will all be touching the ground, because you are placing them on the ground to glue to the body
|
|