|
Post by RHWorldbuilding on Aug 27, 2020 16:45:43 GMT -9
Here is my Single-Figure Submission. Beast-Folk Spellcaster for 25x25mm Square Base. I do my assemby as follows (forgive my clumsy directions) 1-Cut out bases (for front and back art) by cutting INSIDE dotted lines as closely as possible 2-Cut from front base to back base on either side of the image, LEAVE FRONT AND BACK ART CONNECTED (This should leave you with a single piece) 3-Without creasing the paper yet, fold the remaining piece in half so the bases touch (and the printed art is on the OUTSIDE) 4-Line up front and back bases on the bottom and sides and hold them in place 5-Pinch the unprinted sides of the paper all the way to where the "front" and "back" sides of the mini connect and fold at the end opposite the bases (this should leave you with one strip of paper folded directly in half) 6-Fold the base rectangle "out" at the bottom (feet) of the printed image at a 90 degree angle 7-Attach (glue, or double sided tape like I use) the front and back of the folded mini together (the bases should touch, but not be attached to each other with glue or tape) 8-Cut/trim the paper around printed image as closely as you like, if the bases are lined up properly the front and back art will line up precisely. (this will cut off the "top" of the piece of paper, where the fold is) 9-Attach base to 25x25mm Square Base (I use cardstock, but it could be plastic, cardboard etc) Download and a picture of the front and back of the assembled Mini (The PNG looks small, but this page just has a lot of blank space. It's sized to US Letter)
Rob RH Worldbuilding
|
|