|
Post by Vermin King on Sept 8, 2020 5:10:06 GMT -9
|
|
|
Post by Vermin King on Sept 8, 2020 8:02:24 GMT -9
I actually had gotten that far last week and every time I went to proceed, I couldn't see a way to have the feathered overlay to work. The artist who did the model, Y. Watanabe ( creativepark.canon/en/search/index.html?q=Y.Watanabe&categoryIndex=0 ) is a professional model designer, known for a lot of his work commissioned by Canon. When you look at the photo at the top of this thread, you will see that where the white triangle is on the hand part, should be a line for edge gluing, as in the photo. Took me a while to realize that the kit had an error. Didn't want to admit it, really, but there it is. I wish I had seen the problem before printing, so I had to break out the old #2 pencil and hope that it isn't too obvious when done.
|
|
|
Post by Vermin King on Sept 8, 2020 10:59:57 GMT -9
|
|
|
Post by cowboyleland on Sept 8, 2020 21:25:31 GMT -9
|
|