|
|
Post by Tommygun on Feb 7, 2011 22:50:01 GMT -9
Hello, quick question.
Does anyone know of a plastic or vinyl that is compatible with an ink jet printer?
I had this random idea today of designing a printable sail boat that you could but in water.
-Tom.
|
|
|
|
Post by Floyd on Feb 8, 2011 8:59:12 GMT -9
I bought a book full of paper craft boats that are intended for use in water. I'll double-check tonight to see if there is any info on what type of paper it is. Though I have a feeling it's just coated.
In the mean time I see no reason why a double-triple coated acrylic varnish covered sheet of cardstock would be water-resistant at least for a few sails. Longer if not completely submerged.
~F
|
|
|
|
Post by cowboyleland on Feb 8, 2011 9:09:03 GMT -9
Obvious question: What about laminating?
|
|
|
|
Post by Parduz on Feb 8, 2011 9:44:48 GMT -9
I think that the printer's ink is not water resistant.
My MechAttack pieces are coated with a transparent spray.
I dropped (by mistake!) a pair of weapons in the fish bowl and, even if i needed 4-5 seconds before being able to pick them up they are not bent or showing any kind of damage.
So, if i were you i'll try to print the ship, coating it while flat, build it and then coating again. I think it can resist for a lot of time in water.
|
|
|
|
Post by Tommygun on Feb 8, 2011 15:41:09 GMT -9
|
|
|
|
Post by Floyd on Feb 9, 2011 8:15:21 GMT -9
Apparently it works under water too. Make sure the glue you use is also Waterproof. cyanoacrylate...or some such. ~F |
|
|
|
Post by Tommygun on Feb 9, 2011 15:36:37 GMT -9
I have used that E6000 glue on paper models and it worked quite nicely and is flexible.
It's a lot like rubber cement.
Just was thinking it may be a good kids project.
Maybe something for a pool?
|
|
