|
Post by noremorse on Aug 7, 2011 6:24:21 GMT -9
I don't know if this is a problem with 1.7.1 studio, but in 1.5 I found it difficult for my silhouette to pick up the reg. marks if anything was printed at all on the page within the registration zone. While doing Dave's buildings many of his models use up the full cutting area (and then some) so a trick I just discovered is to use a small bit of masking tape to cover over the reg. zone then detect the marks, worked like a dream.
Just thought I would share
|
|
|
Post by dcbradshaw on Aug 7, 2011 8:37:05 GMT -9
As in, taped directly over the registration mark and everything?
Every once in a while I get a page that is stubborn and just won't detect, I'll try this out.
|
|
|
Post by noremorse on Aug 7, 2011 10:23:36 GMT -9
no you have to leave the reg mark exposed
|
|