Witches and bats re-released!

squirmydad ADMIN Emperor Posts: 6,437	Witches and bats re-released! Oct 21, 2013 6:29:10 GMT -9 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by squirmydad on Oct 21, 2013 6:29:10 GMT -9 By the lackwiting of my thumb something wicked this way comes... Witches and Bats
	onemonk.com/

cowboyleland Illuminator Scribe Iconoclast and Heretic Posts: 3,799	Witches and bats re-released! Oct 25, 2013 17:59:50 GMT -9 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by cowboyleland on Oct 25, 2013 17:59:50 GMT -9 So THIS is where WackyAnne got her avatar!
	On the other hand, maybe it's the herd that is crazy.

WackyAnne
Illuminator Scribe

Hangin' with my gnomeboys...

Posts: 983

Witches and bats re-released! Oct 25, 2013 19:01:26 GMT -9

Quote

Post by WackyAnne on Oct 25, 2013 19:01:26 GMT -9

Hehe, yeah, there wasn't a lot of choice for female avatars (I recall a ghost/ghast, and not much else), the crop makes her rather more 'cheesecake' than I'd normally go for in an avatar, but I like her alot.

She'll be great for when I play the changeling witch I have planned once I've Pathfinder down pat. Halloween/LARPing would be fun to try too. Not many people could pull off a PF changeling IRL, but I've the eyes for it. I could probably pull off the costume with the proper bustier and some hair extensions, but I think I'll go with pirate again this year, or Superwoman now that I've the proper boot covers...

Cap'n Anne of the Good Ship Thornless

With apologies to @ squirmydad for de-railing his thread

Now I think I really must try to replicate her costume!

squirmydad ADMIN Emperor Posts: 6,437	Witches and bats re-released! Oct 26, 2013 18:57:20 GMT -9 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by squirmydad on Oct 26, 2013 18:57:20 GMT -9 No problem. You should sketch up that pirate face and make more personalized avatar.
	onemonk.com/

Cardstock Dane: ForestB, Tell me about it! I had big problems last year, loads of under extrusion, which I couldn't understand - until I realized, that the new filament I had bought needed a lower nozzle temp.

Mar 26, 2023 23:52:13 GMT -9 *

ForestB: Cardstock Dane, don't mention those evil devices!

Spent two 'fun' hours last night unclogging a heat break tube (the nozzle was a lost cause and replaced). Stupid bowden tube slipped and molten plastic spilled up into the heat break tube and congealed. Mar 22, 2023 12:25:21 GMT -9

ForestB: Hello there, creyates! Doing okayish, still creating though about to shift back into full builder mode to prep for a campaign. Mar 22, 2023 12:20:50 GMT -9

Post by squirmydad on Oct 21, 2013 6:29:10 GMT -9

Post by cowboyleland on Oct 25, 2013 17:59:50 GMT -9

Post by WackyAnne on Oct 25, 2013 19:01:26 GMT -9

Post by squirmydad on Oct 26, 2013 18:57:20 GMT -9

Shoutbox